Guangzhou Mega-Beautyequipment Commerce Co., Ltd.
Main products:Beauty equipment,facial and hair beauty products,slimming equipment,skin lifting equipment,beauty instruments
Products
Contact Us
  • Contact Person : Ms. Yang Echo
  • Company Name : Guangzhou Mega-Beautyequipment Commerce Co., Ltd.
  • Tel : 0086-20-86417570
  • Fax : 0086-20-86417570
  • Address : Guangdong,Guangzhou,No.501,Flower Road,Baiyun district,Guangzhou
  • Country/Region : China
  • Zip : 510000

T-23 Fat Meter

T-23 Fat Meter
Product Detailed
About errors If error appears in the measuring result (see figure 6).Possible causes include: your fingers are put incorrect.

Operating instructions

1.    After the battery is loaded,LCD will display in full screen for 2 seconds,then enter clock mode following the sound Bi;

2.    Press MODE to switch between three modes,i.e. clock,measure,alarm clock and select a desired mode,press SET to set basic data.

3.    Setting basic data:

*In clock or alarm clock mode,press SET and hold it for 2-3 seconds toenter the setting of group of clock or alarm clock.Press SET again to enter the setting of basic data,when basic data blinks,press to select desired value,press MODE to confirm and save it in the memory at the same time.

*In measuring state,press SET to enter the setting of basic data,enter the basic data for different group,e.g. weight/height/age/sex,for accurate meansuring and calculating.

*The above said basic data entries in the memory is supported by the power supply of battery,so after replacing battery,all data should be reset.

4.    When entering measuring state,press to switch to the basic data of the previously set group before the people to be measured.

*To measuring a new people,selet and set one group following the procedures of setting basic data described above.

*If you have confirmed the group of basic data to be set,press START to measure body fat ratio,the moment LCD will display as figure 3 shows.put your thumbs on both measuring poles and slightly stress them(see figure 4),the system will automaqtically detect and measure.

*The system will work out body fat ratio after 5 seconds and display the results in the screen ,and also read the symbol signifying the degree of fat(see figure 5).

5.    About the measuring of body fat

*The hydration reaction of body will affect read out of fat.Generally,it is the hightest within hours after getting up[ in the moring,because of the loss of the water in body after sleep over night.To maximize the accuracy of the read out ,it is recommended to measure the fat at night,the measureing results of body fat may differ with when you measure on the same day,however,if you measure your fat at the same clock every day and under the same conditionsm,you will et a correct result of the ratio of your fat.

*Measuring your fat twice a month is recommended.

About errors

If error appears in the measuring result (see figure 6).Possible causes include:

*your fingers are put n incorrect postion after pressing MEASURE.

*Your fingers are too dry while measuring.

*Your fingers are not stressed to the poles while measuring .

*The stress is not high enough thus result in bad contact.

Power supply and battery

*This system uses one Cr2025 lithium battery.

*When replacing batterie,use a coin to open the cartridge cover .Please not the battery are installed with anode and cathode fit properly.

*** It is highly recommended to have technicians help replace the battery.

T-23 Fat Meter



Copyright Notice @ 2008-2012 ECVERY Limited and/or its subsidiaries and licensors. All rights reserved.